APM
All alarm codes
ALARM 814

Unfinished Tool Set

Tool 1 in the Tool Data page has not been configured, even though the program only calls T8. The T-32 requires Tool 1 to be set up before any other tool numb...

Controls
T-32, T-32B
Machine series
Quick Turn

Causes

  1. Tool 1 in the Tool Data page has not been configured, even though the program only calls T8. The T-32 requires Tool 1 to be set up before any other tool numbers can be used.

    • adammforum
      I think I have this one licked. I did two things: 1) Set the date and time on the clock. 2) Set-up Tool 1. ... So, it appears T1 needs to be configured on this control to do any work?!

  2. Letter suffix mismatch between the program tool call (e.g. T8A) and the Tool Data page (e.g. T8) — the fields must match exactly.

    • Philabusterforum
      like Ender said, there is nothing indicating a letter A. The fields need to match from the program to the tool data page.

How to clear it

  1. 1

    Open Tool Data (1) and Tool Data (2). Make sure Tool 1 has data entered even if the current program does not use it. Then re-press Check Continue.

    • adammforum
      When I set tool 1, I wrote another short program and had T1 as roughing and T8 as finishing, and it worked. Then I went back to my other program and set it to be T1 and T8, and it worked there too. Then I set my original…
  2. 2

    Verify every tool letter suffix in the program matches the Tool Data page exactly — if the program says T8A, the Tool Data row must read T8A (or both must be plain T8).

    • EnderDRMforum
      Cancel the letter designation in the program, Make "T8A" "T8".

Confidence: high · Two independent causes named in the same thread (T1-must-be-configured + letter-suffix mismatch), operator confirmed both fixes resolved the alarm, plus Philabuster (Diamond member) corroborated the letter-suffix point.

First sourced: 5/21/2026